Final Touch Builders Inc. — Building Contractor & Roofing

Certified Building Contractor CBC1265305 · Certified Roofing Contractor CCC1334811

Fence Installation & Repair, repaired or rebuilt in Lighthouse Point, FL

Fence Installation & Repair for homes in Lighthouse Point and the surrounding area — permitted, inspected and closed out. Free estimate.

Along Lighthouse Point's canals near Hillsboro Inlet, a new fence usually starts with a permit and ends with a final inspection. A fence that is leaning, rotted, rusted at the hinges or flattened after a storm often means salt air, humidity and wind have been working on it for a while. Many waterfront homes sit within a few hundred feet of brackish water, so fence posts, fasteners and gate hardware here wear faster than they would inland.

Final Touch Builders is a general contractor that repairs, remodels and builds, so a fence can be handled alongside other exterior work under one permit. We give you a free estimate and a written scope before work starts. When the job needs a permit, we pull it under our own state certifications, schedule the inspections and close the permit out at the end.

Lighthouse Point is built around deep-water canals, and salt spray corrodes gate operators, hinges, latches and fasteners faster here than in inland Broward. Much of the original 1950s–70s block-and-stucco housing is being renovated or replaced by custom waterfront homes, so fence lines often have to match new construction or be tied into older walls and driveways. Private driveway gates are common in the area, which puts extra demand on hardware and motors. Add a wet season from roughly June through October and a hurricane season that brings real wind loads, and fence footings, post material and gate hardware matter as much as how the fence looks.

Permits, inspections and close-out in Lighthouse Point

In Lighthouse Point, a new fence or wall typically needs a permit from the city's building and zoning departments. The review usually covers height, setbacks, corner visibility, materials and footing and wind design. Simple repairs to an existing fence often don't need a permit, but confirm with the building department before you start. HOA or architectural approval may also be required. The usual inspection sequence is an in-progress inspection where the code requires one, such as post anchoring or footings while they're still visible, then a final inspection. Exact inspections vary by city, so verify them with the building department. Broward County is in the High-Velocity Hurricane Zone, so wind design deserves attention. The Florida Building Code governs structural design for site wind loads, and local zoning controls height and placement. After the final inspection, the permit should be closed out. Unpermitted or open permits can surface at sale, refinance or insurance renewal and can be cited by code enforcement. Florida's regulator is the Department of Business and Professional Regulation (DBPR). There is no separate statewide contractor license specifically for fencing, and fence work is commonly handled under a local specialty license, registration or business tax receipt, so requirements vary. Our work is done under our state certifications, Florida Certified Building Contractor CBC1265305 and Certified Roofing Contractor CCC1334811, both verifiable on the DBPR website. If the fence serves as a pool barrier, confirm the specifics with the building department first.

Verify our licenses at Florida DBPR.

Problems to watch for in Lighthouse Point

Storm-flattened panels

Hurricane and tropical-storm wind can push over wood and vinyl panels or snap posts. Repair or rebuild depends on how many posts lost their footing.

Rot and termite damage in wood

Constant humidity and the summer wet season break down wood posts and rails, especially near the ground. Termites can hollow out wood that still looks sound.

Corroded gate hardware

Salt-laden air from the canals and Intracoastal attacks hinges, latches, drop rods and gate operators. A gate that sags, sticks or won't latch is often a hardware problem.

Fence that fails pool barrier rules

A fence serving as a pool barrier must meet Florida's requirements for height, gaps, non-climbable surfaces and self-closing, self-latching, outward-swinging gates. Worn latches or gaps can put it out of compliance.

Height or setback conflicts

City zoning controls fence height, location and materials. A fence that doesn't follow those limits can be cited, so check before building or replacing.

Leaning posts from weak footings

Posts set shallow or without proper footings lean as the ground softens in wet weather. Wind loads then make the problem worse.

What we do

  • Privacy, pool and decorative fencesWe install fences in wood, vinyl, aluminum and chain link, matched to the property and to the rules for where the fence sits.
  • GatesWe install and repair gates, with attention to hardware that stands up to salt air and, for pool fences, to self-closing, self-latching operation.
  • Fence repairsWe assess whether damaged panels, posts or rails can be repaired or whether the run needs replacing, and put the answer in a written scope.
  • Permit with surveyWhen the work needs a permit, we handle the application, including the survey, and pull it under our own certifications.
  • Inspections and close-outWe schedule the inspections, see them passed and close the permit out. The job is finished when it is permitted, inspected and closed.

When to call

Fence replacement demand spikes after hurricanes and strong storms, and in Lighthouse Point, storm-prep rushes tend to come in late summer, ahead of the peak of hurricane season. Installation is generally easiest in the drier winter and spring months, when ground conditions and concrete work cooperate. The November–April season, when seasonal residents return, is also a natural time to look at fences and gates. To get started, call (954) 620-7812 or request a free quote with the form on this page.

We serve Lighthouse Point, including the Yacht and Racquet Club area, Venetian Isles, Coral Key Villas, the Hillsboro Inlet waterfront canals, and the areas around Dan Witt Park and Frank McDonough Park, plus nearby Hillsboro Beach, Sea Ranch Lakes, Pompano Beach and Deerfield Beach.

Fences in Lighthouse Point: questions we hear

Do I need a permit for a fence in Lighthouse Point?
New fences and walls typically need a permit, while simple repairs of an existing fence often don't. Confirm with the Lighthouse Point building department before work begins, since height, setback and material rules are local.
Does the Miami-Dade product approval apply to my fence?
Broward County is in the High-Velocity Hurricane Zone, and fence structures are designed for site wind loads under the Florida Building Code. Ask the building department whether any product in your design needs approval.
Will salt air from the canals shorten my fence's life?
It can. Salt spray near the canals and Hillsboro Inlet corrodes gate hardware, hinges, latches and fasteners faster than inland conditions. Material and hardware choices matter here, and we can go over options in the written scope.
My fence surrounds a pool. What should I know?
A fence used as a pool barrier must meet Florida's requirements for height, gaps, non-climbable surfaces and self-closing, self-latching, outward-swinging gates. Confirm the specifics with the building department before relying on it.
What happens if a fence was built without a permit?
Unpermitted or open permits can come up at sale, refinance or insurance renewal and can be cited by code enforcement. Contact the building department about how to resolve it.

Request a free fences estimate in Lighthouse Point

Tell us about the project. A state-certified contractor will get back to you.

Prefer to talk?

(954) 620-7812

We only use your details to respond to your request. See our privacy policy.

(954) 620-7812Free estimate