Certified Building Contractor CBC1265305 · Certified Roofing Contractor CCC1334811
How can I tell if my roof tarp was installed correctly?
A straight answer from a Florida state-certified contractor — then what you can check yourself and when to call. Free estimate: (954) 620-7812.
A correctly installed tarp lies tight against the roof with no sagging, pooling or flapping. Its edges are held down with wood battens rather than loose nails, it runs over the ridge where the roof allows, and your ceilings and walls stay dry when it rains. You can check most of this from the ground and from inside the house.
Keep in mind that a tarp, or a shrink-wrap cover, is only a temporary cover until the permanent repair. Even a well-installed one is not a fix for the damaged roof.
Why some tarps fail
A blue polyethylene tarp only works if wind and water can't get under it. A tarp fastened through the middle of the roof can leave holes that let water in. A tarp that stops short of the ridge leaves an opening at the top, where rain can run in underneath. Loose edges can flap and lift in wind, and the flapping tears the plastic and works the fasteners loose.
Sun, heat and wind also wear a cover down the longer it stays up. Shrink wrap is polyethylene film heat-shrunk tight to the roof, so it has fewer loose edges for wind to lift. It is designed to last up to about a year (a typical lifespan, not a promise), longer than a standard blue tarp. It is still temporary.
After a widespread storm, contractors and materials may be in short supply across a region, so a temporary cover can end up in place longer than planned. That makes it worth checking early and keeping an eye on it.
What you can check yourself (without going on the roof)
Look from the ground
Use binoculars if you have them. The cover should look smooth and taut, with battens along the edges and no large sags where water could collect.
Check the ridge and edges
Where the roof allows, the cover should run over the ridge, not stop below it. Loose corners, lifted edges or torn plastic mean wind can get underneath.
Listen in wind and rain
Flapping or snapping sounds point to loose edges. Water dripping or running inside during rain means the cover is letting water through.
Inspect ceilings and walls
Look for new stains, bubbling paint, damp drywall or a musty smell after rain. Wet framing and drywall that stay wet can lead to rot and mold.
Photograph and keep records
Take dated photos of the cover and any interior water marks, and keep your paperwork. Talk to your insurer or agent about the damage and how to document it.
When to call a pro
Call a roofer if you see sagging or pooling, torn or flapping sections, a ridge left open, or water getting inside. Don't climb up to fix it yourself. A wet, damaged roof can be unsafe to walk on.
The permanent repair is the next step. A roof repair, re-roof or structural repair typically needs a permit from your city or county building department, followed by inspections and a final sign-off. Whether the temporary cover itself needs a permit is up to that department, so confirm with them. Unpermitted or still-open permits can come up at sale, refinance or insurance renewal and may be cited by code enforcement. We do the roof work under our Florida Certified Roofing Contractor license CCC1334811 and structural and interior repairs under our Certified Building Contractor license CBC1265305, both verifiable on the Florida DBPR website. Call (954) 620-7812 for a free estimate.
What a pro will do
- Assess the coverWe look at how the tarp or shrink wrap is fastened, where it stops, and whether it can hold until the permanent work starts.
- Document the damageWe take photos of the damage before and after the cover goes on, for your records and your insurance claim.
- Write up the full scopeYou get a written scope of everything the storm damaged, including roof covering, decking, framing, fascia, ceilings and walls, before work starts.
- Repair and rebuildWe handle the structural and interior repairs and the new roof. Roofing products follow Florida's product rules, a Miami-Dade NOA in the HVHZ (Miami-Dade and Broward) and Florida Product Approval elsewhere.
- Permit, inspect, close outWe pull the permit when the work needs one, schedule the inspections and close the permit at the end.
Related questions
- How long can a roof cover stay on?
- A cover is temporary until the permanent repair. Shrink wrap is designed to last up to about a year (a typical lifespan, not a promise), longer than a standard blue tarp. Sun and wind wear on either one, so plan the permanent repair rather than relying on the cover.
- Is shrink wrap better than a blue tarp?
- Shrink wrap is heat-shrunk tight to the roof and has fewer loose edges for wind to lift, and it is designed to outlast a standard tarp. Neither one is a repair.
- Does a temporary roof cover need a permit?
- That is up to your city or county building department, so ask them directly. The permanent roof repair or re-roof typically does need a permit.
- What should I do about my insurance claim?
- Photograph the damage, keep records of the cover and any repairs, and talk to your insurer or agent. We can provide before-and-after photos and a written scope of the storm damage to go with your records.
Request a free roof tarping estimate
Tell us what's going on. A state-certified contractor will get back to you.
Prefer to talk?
(954) 620-7812